基板試作を簡単に

フル機能のカスタム基板試作サービス。

どのように我々は助けることができます?

The requirement of beveling on gold finger area

Reason of failed review:

The width of board is less than 45mm. We cannot make beveling in this case.

 

Suggestion:

  If your design include gold finger and need to do beveling, pls pay attention to  below requirements.

1. The length of gold finger area should be ≧ 30mm

2. The thickness of board should be ≧ 1.2mm

3. The spacing from gold finger to the edge of board should be ≧ 1mm

4. Pls design solder mask opening for whole gold finger area, we will not make solder mask bridge.

5.When gold finger needs to be bevelled , the width of board should be more than 45mm. Otherwise, we cannot do the beveling properly. See pic below, the vertical size is less than 45mm , we cannot make beveling by ordinary production line.

pcbway34.png


最終更新日 28/05/2019 👁 13387
コメント (0)
ここでのメッセージは、上記の内容を補足するものであり、注文などの取引操作を対象としたものではありません。 緊急の質問や注文の問題がある場合は、営業担当者にお問い合わせください。
写真をアップする
アップロードできるファイルは合計で5つのみです。 各ファイルは2MBを超えることはできません。 JPG、JPEG、GIF、PNG、BMPをサポート
0 / 10000