基板クイック試作
カスタム基板試作サービス
基板クイック試作
カスタム基板試作サービス
Min Line Width/Spacing:3/3mil, Products used in Industrial control
Max Aperture Ratio:13:1, Thickness is dissymmetry
Min Line Width/Spacing:3/3mil, Products used in industrial control
Min Hole:0.20mm, Products used in Medical electronic
Min Line Width/Spacing:3/3mil, Products used in Industrial control
Min Hole:0.25mm, Products used in Industrial control
Min Line Width/Spacing:3/3.5mil, Products used in Spend products
Min Line Width/Spacing:3/3mil, Products used in Industrial control
Thickness:2.00mm, Multilayer and stratified
Min Line Width/Spacing:3/3mil, Products used in Industrial control
Finished Thickness:1.6mm, Products used in Communication
Finished Thickness:1.70mm, HDI Rig-flex
お問い合わせ!
私達のカスタマーサービス+86-571-85317532
A very, very easy build, and the finished device works perfectly. Note that my photos show a previous generation of the 3D printed case which required a bit of manual trimming around the amp module.
Phil Atkin
Of the 18 boards populated, 1 failed to operate, 1 had issues. The other 16 were operational. The process was pretty seamless - a few issues from my end regarding BOM descriptions, but otherwise all good. I will probably look at some advanced verification next time to ensure better yield rates.
Lucinsky
