NodeMCU with 4 Channel Module
This PCB consists of a NodeMCU with 4 Channel Relay.
The relay module is an electrical switch. It isolates the input side from the output side. When it reads input, it uses an electromagnet to turn the switch on or off.
Its output side has three pins – COM(Power Supply), NC(Normally Closed), NO(Normally Open).
NO, and NC has the load (in this case an LED is being used).
If I give a high input through the input side, NO pin will go LOW and NC pin will go HIGH. Due to its isolation, the output side and input side must be two different circuits. I used two different power supplies for the input (Including NodeMCU) and output sides(COM, NC, NO).
In this PCB, the 5V relay module is combined with NodeMCU.
D6: RELAY 1
D5: RELAY 2
D3: RELAY 3
D2: RELAY 4
For using other GPIOs, connected 2 Headers.
More details can find in the attached Google Drive Link:
https://drive.google.com/drive/folders/1Pv8ly59dDn0wV7kZaqK8FAR1IU_2HzSO?usp=sharing
NodeMCU with 4 Channel Module
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(2)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Engineer
- GPS Tracking Device using TTGO Building an accurate GPS Tracker with live location along with latitude, longitude, speed of the veh...
- NodeMCU with 4 Channel Module This PCB consists of a NodeMCU with 4 Channel Relay.The relay module is an electrical switch. It iso...
- L293D Motor Driver Board This L293D Motor Driver Board is used to control Motors in both directions.
- ATMEGA 328P with L293D It's an Atmega 328P plus an L293D motor driver. It controls both motor direction and speed.
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
284 0 1 -
Naruto Multi-color PCB printed with UV technology
112 2 1 -
-
-
-
-