1answers

[PCB Design] AD20 Study Notes 1/3

1. Setting of the schematic drawing1. Double click the edge of the drawing to enter properties, you can set the drawing, in order to table size, drawing color, drawing size, direction, label, and edg...
1answers

[PCB Prototype] Help to find this pcb boards

Hello guys, I need to find this wpc005050-0001 board. This boards are from speakers Genius SW-HF 5.1 5050 V2, i need to find this board and buy it and i need to have fully working both board...
1answers

[PCB Prototype] Solder Mask on Bottom of Aluminum PCB

Is it possible to add solder mask on bottom 1 Layer Aluminum PCB?
1answers

[PCB Prototype] what is the recommended pad size diameter for 0.4mm pitch BGA

I have a 185-pin IC with a 0.4mm pitch. Is it necessary to use blind and buried vias? Is there a more cost-effective method for wiring? If there is no more cost-effective wiring method, wh...
1answers

[PCB Prototype] How to Make a 12V Lead Acid Battery Charger with CC & CV

helloplease help me.After transferring the file to the altium, the PCB file is faced with error.Please email me if possible.(hosseinjavidian@gmail.com)Thank you
1answers

[PCB Prototype] Can you provide Arduino Sketch for the self balancing Robot?

Can you provide Arduino Sketch for the self balancing Robot? I have the PCB and all the parts are soldered and working, but I'm not a programmer.Thank you very much!czecht@gmail.com
2answers

[PCB Prototype] LED Matrix and Lissajous pattern Generator the 100x LED version?

You mentioned that there is a 100x LED version of this educational project Would it be all possible for you to provide me with the link to the 100x LED version as well as the order number for PCB, The...
4answers

[PCB Prototype] Routing and via to trace clearances

Could someone please tell me if this sub-part will be okay ? (it is incomplete, just a sub-part meant to be integrated onto a board) Will it pass engineering review without issues ? (Options to select...
1answers

[PCB Prototype] Drill diameter meaning in NC drill files ( fineshed hole or drilled hole ? )

Hello!I have a question regarding drill files: How do you interpret the drill diameters in the NC drill files in case of plated through holes by default ? As the finished hole size, or as the drilled ...
1answers

[PCB Prototype] DJI PHANTOM 4 DRONE

Please how long does it take PCBWAY to approve your project ?
1 2 3 4 5 6 7 8 9 10 11 ...
Ranking Name Answers
1 PCBWay Team 8
2 Frederic 3
3 Engineer 1
4 Jegatheesan Soundrapandian 1