|
KiCADKicad
|
ESP8266 Remote Relay
This pcb has a WeMOS D1 Mini with ESP8266 to control the on board relay.
Control of the relay can occur wirelessly, and the ESP8266 UART pins are also available on a header to optionally allow an external RS485 or bluetooth module to be used.
The Github project uses ESP-NOW to communicate between this relay control board and another ESP8266 board that uses a current transformer: https://www.pcbway.com/project/shareproject/SCT013_Current_Monitor_for_ESP8266_cc7ccd2e.html
When the current transformer detects a minimum amount of current present, it uses ESP-NOW to trigger the relay momentarily, wirelessly.
It is used to activate a doorbell chime in a secondary location (basement) when the main floor doorbell rings (it can't normally be heard in the basement).
ESP8266 Remote Relay
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Gadget Reboot
- Op Amp Buffer with In/Out Guitar Jacks The pcb has a guitar input and output jack to easily connect to a breadboard for guitar effect circu...
- 16 Channel Audio Loop Switcher This is a 16 channel audio loop switcher with 16 inputs and 16 outputs.Analog signals within a +/- 5...
- 16 Switches to RS485 Output Commands Up to 16 switches or 5v/gnd logic inputs can be monitored and when asserted (input = gnd), a sketch ...
- MCP42100 Digital Pot Breakout PCB This breakout board for the MCP42100 dual digital pot has headers that are spaced for breadboard com...
- Power Supply DC Jack/Screw Term/0.1" Header Breakout with PTC This breakout board allows connecting a power source via 2.1x5.5mm DC jack, 7.62mm screw terminals, ...
- 16x16 Analog Switch This 16x16 analog crosspoint switch uses two MT8816 8x16 switch ICs cascaded for a larger matrix.The...
- Line Level Stereo Input to 3 Stereo Output Sharing PCB This audio sharing board will take a stereo line input from a 3.5mm jack, buffer it and send it out ...
- MIDI Breakout In/Out/Thru This MIDI breakout board has 5 pin DIN jacks and Type A configured 3.5mm TRS jacks for Midi In, Midi...
- Tandy CoCo Joystick Adapter - Use Digital Inputs for Analog X,Y axis Use 5v/GND digital signals to control the analog joystick input of a Tandy Color Computer.When input...
- Guitar Stomp Switch and LED Breakout Board This PCB takes a 9 pin 3PDT guitar effect on/off stomp switch along with an LED and resistor, and pr...
- HV5222 Breakout Board HV5222 32 bit high voltage shift register breakout boardThe driver chip has open drain outputs that ...
- DTMF Decoder 3.3v MT88L70 This DTMF decoder uses the MT88L70, powered by 3.3v and interfacing with 3.3v GPIO to decode the tou...
- PT2399 Echo IC Breakout Board The PT2399 is a low-fi echo IC with built in ADC, Ram, and DAC.It uses a handful of external resisto...
- CD4040 Binary Counter Breakout PCB Dual 4040 12 bit ripple carry binary counters.Two surface mount counters on a breakout board that fi...
- 555 Adjustable Duty Cycle and Frequency Easy to use 555 oscillator with potentiometers to adjust duty cycle and frequency.The 5 pin header c...
- DMX RS485 to TTL Isolated Adapter with 3 pin XLR This pcb can be assembled as either a DMX transmitter or receiver interface (the BOM is set up to bu...
- Phone Line Simulator (POTS Land Line) Plug an old land line phone or other device into the RJ11 jack, pick up the phone and hear a dial to...
- 1/4" Phone Jack TRS Breakout PCB This PCB accepts 4 stereo 1/4 inch phone jacks and provides TRS connections on 2.5mm headers, which ...
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
338 0 2 -
Naruto Multi-color PCB printed with UV technology
136 2 1 -
-
-
-
-