This is an LED driver which controls an LED strip with a remote and can change the colors/intensity of the lights. It supplies 12v to the LEDs.I want to know if it is possible to replace the IR receiv...
I'm using an arduino and the value in the analog pin needs to be monitored constantly at all points in the program . I’m aware of using a interrupt pin but it will only work when a pin goes high o...
I have a momentary swith wired to a board which has a short press and a long press function. I only need the short press function and I cannot program out the long press one, so I need a hardware solu...
I am buidling this circuit to amplify a signal from a analog sensor. But for some reason, when I build the circuit on a breadboard I get 0v on the output of U1. The output of U2 works fine, so there i...
I know ways of triggering a single SCR using a microcontroller pin. How would you go about triggering multiple SCRs in series using a microcontroller since only the last SCR cathode is connected to gr...
I was planning on using a wifi socket to control this dehumidifier only to find out it's touch sensitive switch which defaults to off when plugged into power. Have you met this? Any way to bypass ...
