ESP32 ESP-32S Development Board 2.4GHz WiFi+Bluetooth Dual Mode
ESP-32S Wifi Bluetooth combo module is ultra high performance and ultra low-power consumption Wi-Fi and Bluetooth combo wireless platform based on ESPRESSIF ESP32 chipset. ESP-32S integrates dual-core processor, 448 KByte ROM,520 KByte SRAM,16 KByte SRAM in RTC, 802.11 b/g/n/e/I Wi-Fi, Bluetooth v4.2 BR/EDR & BLE, clocks & Times, abundant peripheral Interfaces and sercurity mechanism.
ESP-32S Wifi Bluetooth combo module provides SDK Firmware for fast on-line programming and open source toolchains based on GCC for development support. It is designed for Generic low power IoT sensor hub, loggers, video steaming for camera, Wi-Fi & Bluetooth enabled devices, Home automation and mesh network applications, aimed at makers, hardware engineers, software engineers and solution provides.
Introduction:
ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters,
and power management module. The entire solution takes up the least amount of printed circuit board area.
This board is used with 2.4 GHz dual-mode Wi-Fi and Bluetooth chips by TSMC 40nm low power technology,
power and RF properties best, which is safe, reliable, and scalable to a variety of applications.
Features:
CPU and Memory: Xtensa 32-bit LX6 Dua-core processor, up to 600 DMIPS.
448 KByte ROM
520 KByte SRAM
16 KByte SRAM in RTC.
QSPI can connect up to 4* Flash/SRAM, each flash should be less than 16 Mbytes.
Supply Voltage: 2.2V~3.6V
Small volume, easily embeded to other products
Strong function with support LWIP protocol, Freertos
Supporting three modes: AP, STA, and AP+STA
Supporting Lua program, easily to develop
Wifi:
802.11 b/g/n/e/i
802.11 n (2.4 GHz), up to 150 Mbps
802.11 e: QoS for wireless multimedia technology.
WMM-PS, UAPSD
MPDU and A-MSDU aggregation
Block ACK
Fragmentation and defragmentation
Automatic Beacon monitoring/scanning
802.11 i security features: pre-authentication and TSN
Wi-Fi Protected Access (WPA)/WPA2/WPA2-Enterprise/Wi-Fi Protected Setup (WPS)
Infrastructure BSS Station mode/SoftAP mode
Wi-Fi Direct (P2P), P2P Discovery, P2P Group Owner mode and P2P Power Management
UMA compliant and certified
Antenna diversity and selection
Bluetooth:
Compliant with Bluetooth v4.2 BR/EDR and BLE specification
Class-1, class-2 and class-3 transmitter without external power amplifier
Enhanced power control
+10 dBm transmitting power
NZIF receiver with -98 dBm sensitivity
Adaptive Frequency Hopping (AFH)
Standard HCI based on SDIO/SPI/UART ? High speed UART HCI, up to 4 Mbps
BT 4.2 controller and host stack
Service Discover Protocol (SDP)
General Access Profile (GAP)
Security Manage Protocol (SMP)
Bluetooth Low Energy (BLE)
ATT/GATT
HID
All GATT-based profile supported
SPP-Like GATT-based profile
BLE Beacon
A2DP/AVRCP/SPP, HSP/HFP, RFCOMM
CVSD and SBC for audio codec
Bluetooth Piconet and Scatternet
- Comments(0)
You might like
-
YS-AM100 Bluetooth amplifier board high-power KTV microphone audio integrated machine 2.1 channel TPA3116D2$25.00 or 3000 BeansRedeem Now
-
YS-AS21 Bluetooth digital amplifier board module TPA3251 high and low tone adjustment subwoofer 220W x 2 + 350W$29.99 or 3600 BeansRedeem Now
-
ZK-502L module 5.0 Bluetooth 2*50W digital amplifier board HIFI fever high power 2.0 stereo sound enhancement$3.99 or 480 BeansRedeem Now
-
ZK-HT21 Bluetooth Digital Amplifier Module 2.1 Channel with TDA7498E, Bass/Treble Adjustment, Subwoofer Output$25.00 or 3000 BeansRedeem Now
-
ZK-502MT 2.0 Stereo Bluetooth Audio Digital HIFI Amplifier Board Module with 50W*2 High/Low Tone Adjustment$5.99 or 720 BeansRedeem Now
-
-
PCBWay Wireless Module with SI24R1 RF Communication Wireless Module for Data Transmission$1.99 or 240 BeansRedeem Now
-
-
-
LILYGO T-Display-S3 1.9-inch LCD display development board(Touch Version Non-Soldered Pin)$25.99 or 3120 BeansRedeem Now
-
-
ESP32 WiFi Bluetooth Dual-mode Communication Development Board With Camera$9.99 or 1200 BeansRedeem Now
-
-
-
-
-
-