How to make my silkscreen clear and beautiful on PCB ?

To obtain clear text on finished boards, pls make sure the width of legend is 0.15mm and height 0.8mm at least. Better to have the ratio 1:5.

For the negative texts as below picture, pls make sure the width should be 0.25mm and height 1.25mm at least.

Gerber File Extention from Different Software
Generate Gerber files in Eagle
Refuse conductive adhesive technology in pcb manufacture
Notes for Gerber files Generated from Eagle 9.20
Generate Gerber file from Kicad
How to generate Gerber files from DesignSpark
How to generate Gerber files from DipTrace
How to generate Gerber file from AutoCAD
How to generate Gerber files from CircuitMaker
How to generate Gerber files from Proteus
Generate gerber file from Altium(DXP/.PCB.PCBDOC)
What a PCB Is Made Of
What is the X-out board?
How to create a Centroid File(pick place) from Eagle, Altium,Sprint Layout and ORCAD?
Generate Position File Centroid File(pick place) in Kicad
What PCB cases will be charged of extra cost?
How to generate BOM and Pick and Place File in Proteus 8.13
How to generate Gerber from Sprint Layout 6.0
KiCad 7.0 でガーバーファイルとドリルファイルを生成する方法
Eagle 9.6.2 からガーバーファイルとドリルファイルを生成するにはどうすればよいですか?
How to Create a SMD footprint using the Allegro PCB Editor?
How to Create a SMD pad using the Allegro Padstack Editor?
Why the boards miss the cutouts/sots in the files.
Why the non-plated holes /slots in the files are produced as plated holes /slots and cause short circuit problem?
Why the pads don't cover soldermask as designed on gerber files?
Why the vias produced as soldermask opening when I choose tenting vias for my order?
If my design include gold finger and I need to do bevelling, what should I do?
If my gerber file include soldermask and silkscreen layer but I choose no soldermask and no silkscreen on your website, what will you do?
What is your factory’s standard of panel by tab-route?
What is your requirements of V-cut?
How to remind PCBWay to pay attention to special notes ?
What diameter of via is better to have soldermask covering ?
What is not correct for bottom text ?
Can I send the working gerber files to PCBWay for PCB production?
Why did your technical reviewer reject my order? I want it 2 layer even though there is no track on the bottom, I only need the soldering pads.
How to design the half (castellated) holes for PCB?
PCB Manufacturing Terms Glossary
Electronic Terms Glossary

コメント (0)

ここでのメッセージは、上記の内容を補足するものであり、注文などの取引操作を対象としたものではありません。緊急の質問や注文の問題がある場合は、営業担当者にお問い合わせください。

写真をアップロードする：アップロードできるファイルは合計で1つのみです。各ファイルは2MBを超えることはできません。 JPG、JPEG、GIF、PNG、BMPをサポート

0 / 10000

Back

セルフサービス

パスワードを忘れた
問題を報告する
注文を確認する
あなたのパッケージを追跡する
紛争の進行状況を確認する

How to make my silkscreen clear and beautiful on PCB ?

関連記事